Thursday, January 4, 2007

My Current Nemesis

Pictured here on the left is my nemesis. It is the one thing standing between me and a functioning dishwasher. It is a brass elbow fitting and for some reason, it keeps leaking. Curses!!!

I spent most of yesterday on my stomach on the kitchen floor. Installing a dishwasher is not as easy as I thought - which seems to be the same as all the other projects on this kitchen project. I read the installation manual a few times and it seemed pretty straight forward. I installed the electrical supply that the electrician had roughed in. Then I ran the water supply and drain, as per the manual. I tipped the dishwasher onto its back (with the help of Big Bad) and inserted the copper fitting as instructed. Then I spent about an hour trying to fish the electrical supply, water supply and the drain hoses under the dishwasher, and then installing them in a space only 8 inches tall. Trying to get my wrench in there was a challenge. But finally I did achieve the goal and everything looked great. When Dan returned from work, we turned on the hot water and instead of rejoicing, I spent about an hour laying on the floor, watching water drip from this copper fitting. I turned off the water and tightened it some more, but it still leaked. More tightening, more cursing, and more leaking. Argh!!!

It was such a pain getting everything connected that I didn't want to disconnect it all, pull out the dishwasher, put it on its back and try putting the elbow in again. So, I spent another hour laying on the kitchen floor, watching the elbow leak. Then I thought that none of our projects have gone right the first time. It took three tries to get the kitchen sink in properly. The microwave range hood - three attempts too. So maybe the third time is a charm. Should I even bother trying to get it right on the 2nd try?

Finally I admitted defeat, disconnected it all and tipped it on its back. With a clear view of the copper elbow, I could stand above it and really give it hell with my wrench. (Although it deserves more of my aggression.) And in the end, still a tiny bit of moisture is felt on the fitting once it is all back in its tiny opening and reconnected. I admit defeat again. I will deal with it later. For now I will relish the success of having the sink working properly and I'll go make some coffee using the water coming from the new faucet. Hopefully the third time will be a charm in this installation as well.

2 comments:

  1. i don't see any plumbers tape around that fitting. Mike

    ReplyDelete
  2. Hey Mike -- I did put teflon tape on the fitting the first time, but worried that it may have been keeping me from getting it on as tight as possible. On the 2nd try, we went without and it seems to be holding. Fingers crossed.

    ReplyDelete